1. Remove the main board from the unit. Keep the cutout hole away from you.
      This I consider the top of the board.

   2. Flip the board over its vertical axis and look at the underside. 
      The cutout hole is now on the left. Locate IC32 on the right. 
      There are two IC chips, and IC32 is a bit more to the bottom and to the 
      right. The chip is at 3 cm from the right edge and centered vertically.
      Pin 1 is the top right pin.

         16 15 14 13 12 11 10 9
         |                    |
         |  IC31  uPD4094BG   |
         |                    | 
          1  2  3  4 |5  6  7 8  |    o
          o          |           +B8-/
          |          |
          |          |                                      L
          |          +---------(pin13 ic31)------B8W-----o  3
          |                                              o  0
          |                                              |
          |                         8  7  6  5  4  3  2  1
          |                         |                    |
          |                         |   IC32  uPD4094BG  |
          |                         |                    |
          +-------------------      9 10 11 12 13 14 15 16
                                         |
                               ---L8------+



   3. Above pin 1 you will see two vias. 
   The first via is connected to pin 1, and the second connects to a horizontal
   trace coming from the left. 
   This trace is B8W and goes to the emitter of the PNP Q38 transistor.
   Cut the trace just before the via. 

--- alternative not recommended ---

   2. Remove the shield from the top of the board. There are 30-40 solder points from the shield to the board.

   3. Under the board on the top of the board, remove R-353 and Q-38. They are located to the left of the IC-36 chip on the top of the board under the shield. 

--- alternative ends ---

   4. On the underside of the board, Locate IC-32. 
   There are two IC chips. 
   IC-32 will be just down and to the right of the shield.

   5. Using a pointer, point at the left upper pin, and go toward the top of 
   the board. You will find a trace that stops. 
   It comes out from under IC-31, pin 14, and stops. 
   It should be the sixth trace up from the top of the Chip.
   This signal activates the VHF preamp.

   6. Using a Xacto knife, (or something similar) Cut the trace in the bend
    halfway between IC-31 and the solder point (via).

   7. Make a jumper wire, and jump the connection, from Pin 11 of IC-32 to the
    newly isolated trace. 
    Alternative: solder the wire from the via at pin 1 (bottom left pin) of IC31
    and the newly isolated via.

   8. Reassemble the radio. 

Transmit from 200 kHz to 200 MHz continuous (works from 1 MHz, Tx HPF)